Condensing Tumble Dryer Instruction Book You must read these instructions prior to using the appliance and retain them for future reference.
Contents Safety Advice Electrical Requirements Features - Get to know the main parts of your Dryer Where to put and vent your Dryer How to use your Dryer The Controls Sorting your laundry Wash Care Labels Items requiring special attention Emptying your Water Container Easy Care programme Guide to Drying Times Caring for your dryer If something goes wrong 3-4 5 6 7 8 9-12 13 14 15 16 17 18 19 21 Retention of this Instruction Book This Instruction Book must be kept handy for reference as it contains importa
For your safety IMPORTANT Using your Tumble Dryer is easy. Nevertheless, for your own safety and to get the best results it is important to know your Dryer by reading right through this handbook before using your dryer for the first time. NEVER NEVER NEVER NEVER NEVER NEVER NEVER NEVER NEVER NEVER NEVER NEVER NEVER NEVER ● Allow children to play with or otherwise interfere with the dryer. ● Allow the air inlet at the front of the dryer or the air outlet at the back to be obstructed.
For your safety ALWAYS ● Empty the Water Container after EACH drying cycle. ALWAYS ● Finish every programme with the cool tumble cycle provided on the control. ALWAYS ● Clean the filter, it is essential that the filter is kept clear of fluff after EACH drying cycle. ALWAYS ● Ensure Condenser is free of fluff, regular cleaning is recommended. ALWAYS ● When the dryer is not in use, switch off, remove plug and close the door. ALWAYS ● Comply with the specified electrical requirements.
Electrical Requirements WARNING: This appliance must be earthed! Supply REFER TO THE RATING PLATE FOR VOLTAGE AND CURRENT REQUIREMENTS. (see diagram for location.) The flexible mains lead is supplied fitted with a BS1363 plug and with a 13 amp BS1362 fuse. The plug should be connected to the mains supply via a suitable switched socket which is accessible after installing your dryer. Changing the fuse If it is necessary to fit a replacement fuse, it must be a 13 amp ASTA approved to BS1362 type.
Features - Get to know the main parts of your dryer see "The Controls" Push here to open door NOTE: If your dryer is new wipe out the inside of the drum before you first use it to remove any dust which may have accumulated during transit.
Where to put your dryer ● Your Tumble Dryer should NOT be located adjacent to a gas hob, cooker, heater or eye level grill as flames from the burners could cause damage to your dryer. ● When the dryer is fitted under a work surface, allow space for air to exit the rear grille, a 15mm gap each side of the dryer is recommended. This airflow is essential to condense the water produced drying the washing.
How to use your dryer 1. Plug in, switch on electricity. WARNING: WHEN SWITCHING ON OR OFF, PLEASE ENSURE THAT YOUR HANDS ARE DRY 2. Sort your laundry (see section “Sorting Your Laundry”) 4. Always check the following: 3. Open the door by pressing and releasing the front panel in the position shown. FLUFF FILTER is clean and in place WATER CONTAINER is empty and in place CONDENSER is clean and in place 5.
The Controls - All Models Selecting the required Heat Switch Setting To select high heat (Cottons), the heat selection switch must be In. To select Low heat (Acrylics and Synthetics), the heat selection switch must be Out, a blue indicator will be visible on the top of the switch. See section “Guide to Drying Times”. Starting the Dryer Press and release the START Drying button to commence a drying programme (or delayed start programme on Excel models). The door must have been securely closed first.
The Controls - Advance and First Choice Models Heat Switch (OUT low heat, IN high heat) Audio Switch Filter Care Light (selected models) Setting the timer Start button Empty water light Indicator Turn the timer clockwise to select the required drying time. The drying time for both heat settings is controlled by the timer. All you have to do is turn the timer control clockwise until the required time appears in line with the indicator.
The Controls - Excel Models Heat Switch (OUT low heat, IN high heat) Audio switch ECO Drying Light Start button Empty Water Light Indicator Turn the knob clockwise to select the required programme. To set the required programme all you have to do is turn the Timer Control clockwise until the required selection appears in line with the indicator. Never wind the timer control anti-clockwise. THE START BUTTON MUST BE PRESSED TO START ALL PROGRAMMES INCLUDING A DELAYED START PROGRAMME.
The Controls Excel Models (continued) (ii) Delayed Start When using the time delay, select the number of delay hours you Automatic Drying require before the drying programme is required to start. Select the delay period by rotating the timer knob in a clockwise direction, to the number of hours delay you require (maximum 8 hours). The dryer will start its programme when the time selected has elapsed.
Sorting your laundry 1. Always separate laundry into the correct fabric groups before washing and drying. 2. See that all zips are closed, hooks and eyes are fastened and belt, strings etc. are tied loosely in bows, you will normally have done this for each item before the washing stage. 3. It is important to extract as much water as possible from each item before drying. This saves you time and money. WARNING: CLOTHES SHOULD NEVER BE LOADED DRIPPING WET 4.
Wash Care Labels Most of today’s fabrics can be tumble dried in your Dryer with no trouble at all, but there are certain fabric finishes which should be dried away from direct heat. The majority of garments now have wash-care labels on them, giving full washing and drying instructions. These should always be followed carefully especially when you are drying something for the first time.
Items requiring special attention Blankets and Bedspreads The drying requirements of blankets and bedspreads will, of course, vary tremendously according to size and weight. Some, however are simply too big. if you have difficulty getting them into the Dryer, the machine will have difficulty drying them properly. Blankets (and Garments) made from Acrylic fibres (e.g. Acilan, Courtelle, Orion and Dralon) must be dried with special care on Low heat setting.
Emptying the Water Container Water Container Water Container Plinth Moulding (not fitted to all models) Sink Empty the water container after EVERY programme. Failure to do this will result in the water container becoming full and the load will not dry. Do not block the vent hole in the cap! This hole is essential for correct operation of your dryer. To Empty Water Container Remove plinth (where fitted) by slightly lifting and sliding to the left.
Easy Care Programme - Advance, Excel, Easy Care and ECO Sensor Models Creda ‘Easy Care’ provides a short programme consisting of approximately 7.5 minutes of heat with an approximately 2.5 minutes cool tumble period. It is a short conditioning programme that softens the fibres allowing them to relax making handling and ironing easier and less time consuming.
Guide to drying times Please note that the drying times stated below and on appliance control panel; are a GUIDE only and drying times are affected by:The amount of water remaining in the clothes after spinning Items such as towelling retain a lot of water after spinning, also the suggested wash programme for small items such as T-Shirts may sometimes incorporate a low spin speed which has the same effect.
Caring for your Dryer When finished Your Tumble Dryer needs very little attention. The following simple steps will keep it performing well. Switch off electricity and remove plug. Ensure hands are dry. After each load Always clean the filter, by rinsing under the tap or using a vacuum cleaner. Turn the dryer by hand to check that small items like handkerchiefs do not get missed. Every Week Wipe the drum and seal with a damp cloth.
Spare parts Please remember your new appliance is a complex piece of equipment. ‘DIY” repairs or unqualified and untrained service people may put you in danger, could damage the appliance, and might mean you lose cover under the Parts Guarantee. If you do experience a problem with the appliance don’t take risks, call in our Service Engineer. Our Spare Parts are designed exclusively to fit your appliance. Do not use them for any other purpose as you may create a safety hazard.
If something goes wrong First, don’t panic! There may be nothing wrong at all. Look for your problem below, then check the things we suggest. More often than not, this will give you the answer to your problem, and you’ll be able to carry on without having to telephone your Service Office. If after this you still cannot get your machine to work, follow the advice given on the next page. Problem Check these things first ‘It won’t start’ 1. 2. 3. 4.
Key Contacts Service Creda has the largest appliance manufacturer’s service team in Europe, trained specialists directly employed by us to ensure your complete confidence. Repair Service UK: 08709 066 066 Republic of Ireland: 1850 302 220 You will be asked for the following information:Name, address and postcode.