Electric Heater User Manual

ManualsBrandsCreda ManualsElectric HeaterTPR2-1000W

Installation and Operating Instructions

TPR II Wall Mounted Panel

Convector Heaters

Dimensions (mm)

Model(s)

Part number Watt A B

TPR2-750W / TW

75-773401 / 75-773411 750 620 108

TPR2-1000W / TW

75-773402 / 75-773412

1000 620 108

TPR2-1250W / TW

75-773403 / 75-773413 1250 688 108

TPR2-1500W / TW

75-773404 / 75-773414 1500 688 108

TPR2-2000W / TW

75-773405 / 75-773415 2000 860

108

IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE

Important Safety Advice

When using electrical appliances, basic precautions

should always be followed to reduce the risk of fire,

electrical shock, and injury to persons, including the

following:

IMPORTANT - The wall brackets supplied with the

appliance must be used.

IMPORTANT - If the heater is installed in a room

containing a bath or shower, it must be so installed that

switches and other controls cannot be touched by a

person using a bath or shower.

Do not use outdoors.

Do not locate the heater immediately below a fixed socket

outlet or connection box.

Do not cover the heater. Do not place material or

garments on the heater, or obstruct the air circulation

around the heater, for instance by curtains or pushing

furniture up against the heater, as this could cause

overheating and a fire risk.

NEVER cover or obstruct in any way the heat outlet slots

at the top of the heater or the air inlet slots in the base of

the heater.

The heater must not be covered.

WARNING -THE SURFACES OF THIS HEATER CAN BE

HOT. Momentary contact with any part of the heater

should not cause injury. However, aged or infirm persons

or young children should not be left unsupervised in the

vicinity of the heater unless a suitable guard is fitted.

This appliance is not intended for use by children or

other persons without assistance or supervision if their

physical, sensory or mental capabilities prevent them

from using it safely. Children should be supervised to

ensure that they do not play with the appliance.

Note that due care and consideration must be taken

when using this heater in series with a thermal control,

a program controller, a timer or any other device that

switches on the heat automatically, since a fire risk

exists when the heater is accidentally covered or

displaced.

If the supply cord is damaged it must be replaced by the

manufacturer or service agent or a similarly qualified

person in order to avoid a hazard.

Electrical

WARNING-THIS APPLIANCE MUST BE EARTHED

The electrical installation must be carried out by a competent

electrician, and be in strict accordance with the current I.E.E.

regulations for Electrical Equipment in Buildings.

The heater is fitted with a length of flexible cable type

H05VV-F size 3 x 1.0mm

on all models for connection

to the fixed wiring of the premises through a suitable

connection box positioned adjacent to the heater.

A means for disconnection in all poles must be provided

in the fixed wiring in accordance with the wiring rules.

Supplementary Earth Bonding

Should Equipotential Earth Bonding be required, the earthing

conductor in the supply cord is deemed to provide the

supplementary bonding connection (see Regulation 547-

03-05, 16

Edition I.E.E. Wiring Regulations).

General

The TPR Convector is designed for wall mounting on the wall

brackets supplied. It should only be operated when in the

upright position as shown.

All models are protected to IP24 standard.

Models TPR 2....W are fitted with a thermostat only.

Mod els TPR2….TW are fitted with a thermostat and a 24 hour timer.

Before connecting the heater, check that the supply voltage is

the same as that stated on the heater.

Fig 1

Summary of content (4 pages)

PAGE 1
Installation and Operating Instructions TPR II Wall Mounted Panel Convector Heaters Dimensions (mm) Model(s) TPR2-750W / TW TPR2-1000W / TW TPR2-1250W / TW TPR2-1500W / TW TPR2-2000W / TW Part number Watt A B 75-773401 / 75-773411 75-773402 / 75-773412 75-773403 / 75-773413 75-773404 / 75-773414 75-773405 / 75-773415 750 1000 1250 1500 2000 620 620 688 688 860 108 108 108 108 108 Fig 1 IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE Important Safety Advice
PAGE 2
Wall Mounting Thermostat Operation IMPORTANT -The wall brackets supplied with the appliance must be used. The heater should be positioned observing the minimum clearances stated around the heater - see Fig.1. The heater is fitted with an adjustable thermostat enabling the room temperature to be controlled by adjusting the setting accordingly. The * setting represents a room temperature of approximately 5°C and may be used for protection against frost. Higher temperature settings range from 1 to 6 (max.
PAGE 3
Automatic Operation Cleaning Set the timer switch to position. The panel will now operate during set 'ON' periods under the control of the thermostat. Before commencing cleaning, unplug the heater and allow it to cool. Disconnect the electricity supply to the appliance. To set the timer's 'ON' and 'OFF' periods: 1. Using your finger tip or the tip of a pencil, push in as many segments as nec essary a round the di al, according to the times you don't require heat - see Fig. 6.
PAGE 4
Energy Saving Tips Other Energy Saving Tips for Around the Home The energy we use to heat, light and power our homes contributes over a quarter of the UK's carbon emissions, the principle contributor to climate change. 1. Lights Around half the energy used in the home is for heating and hot water, so using your heating system efficiently will not only help the environment, but also save you money ! Energy efficiency tips for heating and hot water 1.