Instruction Manual Tumble Dryer

Installation of your Dryer

There is no internal packing to be removed before use, but make

sure the drum is empty. Wipe the inside of the Drum before use to

remove any transit dust. Your Dryer does not blow moist air into

the room, avoiding the requirement of a vent hose.

Position the Dryer where air can freely circulate around it, a 15mm

gap each side is recommended.

The door of your Dryer is reversible and can easily be changed

before installation. Exchange diagonally the hinge brackets for

blanking plugs. Exchange door latch and catch with their

opposing blanking plates. See diagram above.

Support the weight of the door when removing hinges.

Dryers can be to permanently stack on top of Washing machines,

saving valuable floor space. The Dryer should not be

located next to a hob, cooker, heater or high level grill, as heat

from these appliances could cause damage. When ordering you

must state the product numbers of the Washing machine and

Tumble Dryer (Tel. No. 0541 530 530).

Note: Separate mains plugs and sockets must be used for each

appliance. Do not use 2-way adaptors or extension leads.

As the dryer is heavy assistance should be obtained when

stacking the dryer.

HINGE

DOOR

LATCH

DOOR

CATCH

Location

Door Reversal

Instructions

Stacking Your

Appliance