Tumble Dryer Instruction Book TVU1 TVR2 You must read these instructions prior to using the appliance and retain them for future reference
Important Information GB For your Venting dryer to operate efficiently, you must follow the regular maintenance schedule shown below: Fluff Filter... ! You MUST clean the fluff filter after EVERY drying cycle. STEP 1. Open the door of your dryer. STEP 2. Pull out the filter (using the two finger grips). STEP 4. Refit the filter. - Make sure the arrows are facing you. STEP 5. Make sure the filter is pushed fully home. - NEVER run the dryer without the filter in position. STEP 3.
Instruction booklet TUMBLE DRYER Contents GB Installation, 4-5 Where to put your dryer Ventilation Electrical connection Before you start using your dryer Dryer description, 6 The front The back Control panel Start and programmes, 7 Choosing a programme Laundry, 8-9 Sorting your laundry Wash care labels Special clothing items Drying times Warnings and Suggestions, 10 General safety Disposal Saving energy and respecting the environment Maintenance and Care, 11 Switching off the electricity Cleaning t
Installation GB Where to put your dryer Permanent venting Place your dryer at a distance from gas ranges, stoves, heaters, or cook tops because flames can damage the appliance. ● If you are going to install the Minimum gap 10mm appliance under a work counter, be sure to leave a 10mm space between the top and any other objects on or above the machine and a 15mm space between the Minimum gaps 15mm sides and lateral furnishings or walls. This is to ensure proper air circulation.
Open window venting Changing the plug GB The wires in the power cord are coloured in accordance with the following: Green and Yellow (Earth) wire to terminal marked ‘E’, symbol , or coloured green and yellow. Blue (Neutral) wire to terminal marked ‘N’ or coloured black. Installation The end of the tube should be directed downwards, to prevent warm moist air from condensing in the room or in the dryer. 13A ASTA approved fuse to BS1362. Brown (Live) wire to terminal marked ‘L’ or coloured red.
Dryer Description GB The front The back Control Panel Model & Serial numbers Drum Rating plate Air Intake Vent Vent Tube fitted here Filter Caution: Hot! Control panel HEAT Button Drying Guide The START button begins drying a selected programme (see Start and Programmes). The HEAT button selects drying temperature (see Start and Programmes).
Start and Programmes Choosing a programme 1. Plug the dryer into the electrical socket. 3. Open the door and make sure the filter is clean and in place (see Maintenance). 5. Choose a drying time, the way you do this depends on the type of dryer you have: 7. About 10 minutes before drying is completed, it enters the final COOL TUMBLE phase (fabrics are cooled), which should always be allowed to be completed. Description 4. Load the machine and make sure items are not in the way of the door seal.
Laundry GB Sorting your laundry Wash Care Labels Check symbols on clothing labels to make sure that the articles can be tumble dried. ● Sort laundry by fabric type. ● Empty pockets and check buttons. ● Close zippers and hooks and tie loose belts and strings. ● Wring out each item in order to eliminate as much excess water as possible. ! Do not load dripping wet clothes into the dryer. Look at the labels on your garments, especially when tumble drying for the first time.
Special clothing items Times are approximate and can vary depending upon: ● ● Pleated or creased garments: read the manufacturer’s drying instructions on the garment. ● ● Quantity of laundry: single items or small loads may take longer to dry. Dryness: If you are going to iron some of your clothes, they can be taken out while still a bit damp. Others can be left longer if you need them to be completely dry.
Warnings and Suggestions GB ! The appliance has been designed and built according to international safety standards. These warnings are given for safety reasons and must be read carefully.
Maintenance and Care Check the drum after each cycle Unplug your dryer when not using it, when cleaning it and during all maintenance operations. Turn the drum manually in order to remove small items (handkerchiefs) that could have been left behind. GB Installation Switching off the electricity Cleaning the drum Clean the filter after each cycle ! Do not use abrasives, steel wool or stainless steel cleaning agents to clean the drum.
Troubleshooting GB One day your dryer seems not to be working. Before you call your Service Centre (see Service), go through the following troubleshooting suggestions: Problem: Possible causes / Solution: The dryer won’t start. ● ● ● ● ● ● ● It is taking a long time to dry. ● ● ● ● ● ● ● ● 12 The plug is not plugged into the socket, or not making contact. There has been a power failure. The fuse has blown. Try to plug another appliance into the socket.
Service Before calling the Service Centre: ● This dryer is a complex machine. Repairing it yourself or having a non-authorised person try to repair it could cause harm to one or more persons, could damage the machine and could invalidate the spare parts warranty. Call an authorised technician if you experience problems while using the machine. The spare parts have been designed exclusively for this appliance and not for other uses.
195059221.00 W 08/2006 - SIMLEX . Four Ashes, Wolverhampton Key Contacts After Sales Service Over 1100 trained specialists, directly employed by us, ensure that you can have complete confidence in both the appliances and services we offer. Repair Service and Information Help Desk UK: 08709 066 066 Monday to Friday, 8am to 7.30pm Saturday, 8.30am to 5.30pm Sunday, 9.30am to 3.30pm www.credaservice.co.
