Installation Manual

LS Series
LED Surface Ambient Luminaire
LS-RJ, Joint Aligner
INSTALLATION INSTRUCTIONS
1 of 1 LPN00262X0001A0_B
www.cree.com/lighting
© 2014 Cree, Inc. All rights reserved. For informational purposes only. Content is subject to change. See
www.cree.com/lighting/products/warranty for warranty and specifications. Cree® and the Cree logo are
registered trademarks.
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should
always be followed including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1. DANGER- Risk of shock- Disconnect power before
installation.
DANGER – Risque de choc – Couper l’alimentation avant
l’installation.
SAVE THESE INSTRUCTIONS FOR FUTURE
REFERENCE
TO INSTALL:
STEP 1:
Place the Joint Aligner over the two
adjoining luminaires. Line up the
mounting holes on the bracket with those
on the luminaire. See Figure 1.
STEP 2:
Secure the Joint Aligner by inserting the
(4) supplied screws as Shown in Figure 1.
1
Joint Aligner
(4) Supplied Screws