Cut Sheet

H4
Four-Inch Architectural Housing
T [phone] F [phone]
www.cree.com/lighting
Product Description
The H4 recessed architectural housing is designed to accommodate the Cree
LR4 LED downlight in a variety of architectural applications. It is rated for use
with luminaires that consume low energy, like the LR4, optimizing energy density
calculations for easier energy code compliance and LEED certification. The H4
housing is IC rated, airtight, inherently protected, and California Title-24 compliant.
Product Specifications
CONSTRUCTION & MATERIALS
Recessed housing accommodates Cree LR4 four-inch LED downlights in ceiling
thicknesses from 0.25" to 1.25".
Gasketed housing enables air-tight fit to eectively isolate housing assembly
from conditioned space below.
Adjustable bar-hangers span from 10.25" to 24.75” without sag. Bar-hanger brake
prevents sliding during installation and holds position once installed.
Suitable for insulated or non-insulated ceilings.
Dimensions: L 14" x W 8" x H 7"
REGULATORY & VOLUNTARY QUALIFICATIONS
cULus Listed
®
IC air-tight rated, tested in accordance with ASTM E283.
Title-24 compliant.
Suitable for damp locations.
Ordering Information
Example: LR4E-30C + H4 + LT4-30A
Fully assembled luminaire is composed of three components that must be ordered separately:
LR4: Light engine H4: Recessed architectural housing LT4: Snap-in architectural trim
Light Engines
LR4E-15
LR4E-15C
LR4E-30
LR4E-30C
Housing
H4
Recessed housing with GU24 socket
Trims
LT4-15A/LT4-30A
Diuse anodized finish trim
LT4-15AW/LT4-30AW
Wheat diuse anodized finish trim
LT4-15AP/LT4-30AP
Pewter diuse anodized finish trim
LT4-15AB/LT4-30AB
Black anodized finish trim
LT4-15WH/LT4-30WH
Smooth white trim
LT4-15BB/LT4-30BB
Flat black finish trim and reflector
NOTE: Light engine and trim reflector depth must match for appropriate fit.
© 2012 Cree, Inc. and/or one of its subsidiaries. All rights reserved. For informational
purposes only. See www.cree.com/patents for patents that cover these products.
Cree®, and the Cree logo are registered trademarks of Cree, Inc. or one of its subsidiaries.
Rev. Date 11/06/2012
H4
7”
8”
14”