User's Manual

ManualsBrandsCree ManualsElectronicsRelay Module

INSTALLATION INSTRUCTIONS

0-10V Interface

Wireless 0-10V Dimming/Switching Interface with SmartCast™ Technology

Includes: CIF-10V-CWC-SNSR

LPN00212X0005A3_B

1 of 3

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precautions should always be

followed including the following:

READ AND FOLLOW ALL SAFETY INSTRUCTIONS

1. Before installing turn off the power at the circuit breaker.

2. Must be installed in accordance with the national and local building codes and

electrical wiring codes including wiring methods and wiring connections. If you

are not familiar with these codes and requirements, consult a qualied electrician.

3. Indoor use only and suitable for damp locations.

4. Any changes or modications to these devices not explicitly approved by

manufacturer could void your authority to operate this equipment.

SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE

• Voltage: 120-277V, 60Hz

• Load Type: 120-277VAC 5-2.1A 600W MAX. (Electric Ballast/ General

Purpose (LED))

• Install using a junction box that has a 1/2" knockout

UNIT DESCRIPTION

The Cree Wireless 0-10V Interface is used to

wirelessly control LED luminaires that do not

have built in Cree SmartCast ™ Technology. The

Cree Wireless 0-10V Interface provides on, off,

and 0-10V dimming control.

LOAD TYPES

0-10V dimmable loads (IEC60929)

INSTALLATION

NOTE: For ease of installation, Cree

recommends using a Junction Box with a ½"

knockout.

STEP 1:

Disconnect power to circuit by turning circuit

breaker OFF before installation.

STEP 2:

Remove Junction Box cover.

STEP 3:

Remove knockout and ﬁrmly install plastic

relay box into Junction Box until it snaps and is

securely attached

STEP 4:

Strip existing Junction Box wires ½".

STEP 5:

Make wiring connection per the Electrical

Connection section.

STEP 6:

Attach Junction Box cover.

STEP 7:

Install sensor into ceiling by drilling a 2" hole

into the ceiling.

Blue LED is Inside the Relay Box, Light

will Shine Through at the LED Placement

Shown Below.

Test/Reset

Button Inside

Blue LED

Placement

This End Insert into

Junction Box

Sensor

Interface Box

Summary of content (3 pages)

PAGE 1
0-10V Interface Wireless 0-10V Dimming/Switching Interface with SmartCast™ Technology Includes: CIF-10V-CWC-SNSR INSTALLATION INSTRUCTIONS IMPORTANT SAFEGUARDS When using electrical equipment, basic safety precautions should always be followed including the following: READ AND FOLLOW ALL SAFETY INSTRUCTIONS 1. Before installing turn off the power at the circuit breaker. 2.
PAGE 2
Large Trim Ring Sensor Ceiling Small Trim Ring STEP 8: RESET Unscrew the small trim ring near the sensor and place sensor assembly through the ceiling. See Figure 2. STEP 1: STEP 9: Secure the sensor assembly by screwing the small trim ring removed in Step 8 back onto the sensor assembly. Tighten the larger trim ring above the ceiling until it is snugged tight against the ceiling. See Figure 2. STEP 10: Switch the circuit breaker ON. STEP 11: The blue LED should repeat a two blink sequence.
PAGE 3
FCC NOTICE INDUSTRY CANADA STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the device.