User's Manual

LPN00212X0005A3_B
3 of 3
www.cree.com/lighting
© 2013 Cree, Inc. All rights reserved. For informational purposes only. Content is subject to change. See
www.cree.com/lighting/products/warranty for warranty and specifications. Cree® and the Cree logo are
registered trademarks, and SmartCast™ is a trademark of Cree, Inc.
ELECTRICAL CONNECTIONS
STEP 1:
Make the following Electrical Connections:
a. Connect the black Wireless 0-10V Interface lead to
the voltage supply position.
b. Connect the white Wireless 0-10V Interface lead to
the neutral supply position.
c. Connect the red Wireless 0-10V Interface lead to the
load supply position.
d. Connect the green Wireless 0-10V Interface lead to
the green wire position of the junction box.
For Dimming make the following connections to the customer
supplied load:
e. Connect the violet Wireless 0-10V Interface lead to
the +10V dimming wire of the load.
f. Connect the grey Wireless 0-10V Interface lead to
the dimming common wire of the load.
LINE
GREEN
LINE-BLACK
GROUND-GREEN
NEUTRAL-WHITE
NEUTRAL
SUPPLY WIRING
0-10V
INTERFACE
JUNCTION
BOX
LOAD-RED
LOAD
FCC NOTICE
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation. Any
changes or modifications not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the device.
This device has been tested and found to comply with
the limits for a Class A digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when
the device is operated in a commercial environment. This
device generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operation of this device in a residential
area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own
expense.
In addition, this device complies with ICES-003 of the
Industry Canada (IC) Regulations.
INDUSTRY CANADA STATEMENT
This device complies with Industry Canada licence-exempt
RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation of the
device. In addition, this device complies with ICES-003 of the
Industry Canada (IC) Regulations.
Le présent appareil est conforme aux CNR d’Industrie
Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes
: (1) l’appareil ne doit pas produire de brouillage, et (2)
l’utilisateur de l’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible
d’en compromettre le fonctionnement.