User Instructions

Table 5.3 RX sensitivity
Parameter
Min
Typical
Max
Unit
RX
sensitivity
1Mbps
-
-94.5
-
dBm
2Mbps
-
-91
-
Frequency offset error
1Mbps
-250
-
+300
KHz
2Mbps
-300
-
+200
Co-channel interference
suppression
-
-
-10
-
dB
6 Module basic instructions
KLMKBM-01 module recommends that users can access the network through the
APP-"zhihui connect" developed by our company configuration.
Two bulbs are needed for control, and our module needs to be soldered to the
corresponding lamp board. If the bulb is pre-configured, you need to perform 5 short
power cycles (on/off every 2 seconds) to reset the bulb.
6.1 Add equipment
 Click "Add Device" in the upper right corner to select the device you need
to add or enter the device name directly, such as RGBCW-BLE.
 The initial device has entered the distribution network mode as soon as the
power is turned on, and then the lights start to flash; if it is a secondary
distribution network, follow the instructions of the distribution network
diagram, and then click the "start adding device" button.
 Search the device, select the corresponding device to ad.
 After the connection is complete, click "Finish" --device rename--choose
a family/room--connection succeeded;