Specifications

74
If hot unit is not working, first check the following causes:
1. Cord is unplugged from wall outlet.
2. Circuit breaker/fuse to wall outlet is blown.
3. Switch(es) are turned off.
4. Thermostat(s) are turned off, or are set too low.
MAINTENANCE
INSTRUCTIONS
WARNING
PROBLEM POSSIBLE CAUSE SOLUTION
Oven does not heat, or does not heat properly 1. Thermostat(s) defective
2. Heater contactor
3. On/Off Switch
4. Fuses
1. Replace
2. Replace
3. Replace
4. Replace
Timer runs down, but oven does not go into
hold mode
1. Timer defective 1. Replace
Heaters will not shut off 1.
Thermostat defective
2. Contactor defective
1. Replace
2. Replace
Vent fans do not shut off 1.
Vent fan switch defective
2. Control compartment is still hot
1. Replace
2. Wait until it cools check “Heaters will not
shut off”
Vent fans do not operate 1.
Vent fan switch defective
2. Vent fan defective
3. Fuses*
1. Replace
2. Replace
3. Replace
IF UNIT GETS TOO HOT OR WON’T SHUT OFF,
DISCONNECT POWER AT BRANCH PANEL. DO
NOT UNPLUG CORD!
*Fuses are in 6000 Watt units only
Note: Vent fans will not operate until the control compartment requires ventilation to limit temperatures.
Replacement of electrical components must be done by a qualified electrician. To locate an authorize
service center, visit www.crescor.com, call 1-877-crescor (273-7267), or refer to our service agency list,
FL-1400 insert.