Owner`s manual

Front Panel Features
MONITOR Output Section
SOURCE SELECT
The Source select portion of the Monitor system allows you to assign the primary mix
buses to the Monitor outputs.
NOTE: All buses are monitored pre-fader (post-insert)
NOTE: All selected sources are added (summed) together.
TAPE IN
Assigns the TAPE IN L & R signals to the monitors. The TAPE IN jacks are located
on the rear panel. 1/4” TRS jacks and RCA phone plugs are provided for easy
hookup.
A1-2 (Aux 1 & 2)
Assigns Auxes 1 and 2 to the Monitor outputs. Auxes 1 and 2 are configured
as a paired-stereo Aux bus (see Mono input channel description). Aux 1 is Left
and 2 is Right.
MONO
Assigns the Mono bus to both the Left and Right Monitor outs.
L-R (Left & Right)
Assigns the Left and Right buses to the Left and Right Monitor outs.
G1-2 (Groups 1 & 2)
Assigns Groups 1 and 2 to the Monitor outs. Group 1 is Left and 2 is Right.
G3-4 (Groups 2 & 4)
Assigns Groups 3 and 4 to the Monitor outs. Group 3 is Left and 4 is Right.
Master Section
3
p. 43