Owner`s manual

p.15
Mono Input channel
1
Rear panel features
48 V Phantom power
48 volts DC is applied to pins 2 and 3 on the mic-input XLRconnector. This
option is used with condenser microphones and active direct boxes that require
an external DC voltage (phantom power ) in order to operate.
Line INPUTjack
Line-level signals, balanced or unbalanced, may be brought into the
input channel through this jack. The LINE INPUT switch must be pressed for this
jack to be active.
MIC INPUT jack
This balanced female XLR accepts a low-impedance microphone signal, or a
line-level signal, depending on the position of the LINEINPUTswitch on the front
panel.
INSERT jack
This switching 1/4” TRS jack allows an external signal processor to be
inserted into the signal path of the channel. The tip carries the SEND signal and
the ring carries the RETURN signal.
DIRECTOUT jack
The channel’s signal can be brought out of the console via the direct
out jack. The signal that appears at this jack is normally post fader. There is an
internal option for making it pre fader.