Owner`s manual

Front panel features

MONITOROutput section

The XR-20 and XR-24 offer an extensive monitoring system which can be used

for several alternate mix and remote listening purposes. The main L/R & M mixes,

the Groups, Auxes 1&2, the Tape IN, and the Solo system can all be routed to the

Monitor outs. Like the Headphone section, the SOLO system is automatically

routed to the Monitors. This can be defeated by pressing the SOLOOFFbutton.

MONITORLevel control

This knob controls the signal level that appears at the Monitor output on

the rear panel. This signal can also be assigned to the headphone system by press-

ing the FROM MONITORbutton located below the Headphone level control.

SUM MONO

The MONITORSystem operates in stereo, and has Left and Right outputs. You

can assign several stereo sources to the Monitor bus,including the Aux 1/2 stereo

pair, the Left/Right busses, the TAPEIN, and the Groups,in stereo odd/even pairs.

The MONITORsystem operates in stereo. . Any stereo signals that are

assigned to the Monitor system remain stereo.

The MONITORsystem operates in mono. Any stereo signals that are

assigned to the Monitor system are summed together.

SOLO OFF

Like the Headphone section, the Solo system is automatically routed to the moni-

tors.

.Solo takes overrides anything that is assigned to the monitors.

The Solo system does not appear in the monitors.

Note

If you are 1) routing the Monitor outs to the Headphone system by pressing the

FROMMONITOR button in the Headphone section, and, 2) you don’t want the

Solo system to show up in the headphones, you must press both SOLO OFFbut-

tons -the one in the Headphone section andthe one in the Monitor section.

Master section

p.35