Owner`s manual

p.43
Master section
3
Rear panel features
AUX Inserts 1 through 6
The Aux masters have pre-fader inserts for patching in signal proces-
sors. This is useful when using Aux outputs for stage monitors. Tip is Send and
Ring is Return.
Aux OUTTRS Jacks 1 through 6
The six post-fader Aux master outputs are available at these 1/4” TRS
jacks.
Aux OUTXLR’s 1 through 6
The six post-fader Aux master outputs are also available at these male XLR
jacks. (pin 2 hot)
Group Inserts 1 through 4
The Groups have pre-fader inserts for patching in signal processors.
This is useful when using Group outputs for recording or stage monitors. Tip is
Send and Ring is Return.
Tape (line) in
The Left and Right Tape inputs are available as both 1/4” TRSand
RCA.
Alt Out
The Left and Right Alternate outputs are available as both 1/4” TRS
and RCA.
Monitor out
The Left and Right Monitor outputs are available as both 1/4” TRSand
RCA.
Left, Right and Mono Main Inserts
The Left, Right and Mono buses have pre-fader inserts for patching in
signal processors. Tip is Send and Ring is Return.
Left, Right and Mono main Outputs
The Left, Right and Mono post-fader signals appear at these male XLR’s.
Mic/Line Switches for Left, Right and Mono main outputs
These switch are recessed to prevent the from accidentally being hit
Output levels are presented at line level for feeding the line inputs on a sig-
nal processor, another mixer, or a power amplifier.
Output levels are reduced to mic level for feeding the Microphone inputs
on a signal processor or another mixer. Outputs are protected against phantom
power.