Operation Manual

p. 3

introduction

welcome

Congratulations on your purchase of a new CPX Series power amplifier, and

thank you for your confidence in Crest Audio products. You are among the grow-

ing number of audio professionals who have made Crest Audio one of the world’s

leading suppliers of professional and commercial/industrial audio systems.

For your safety, please read the Important Precautions section before installing

and operating the amplifier. The Crest Audio CPX Series amplifiers are designed

for high operating efficiency and accurate sonic performance across the full audio

bandwidth, even under stressful conditions.

CPX series amplifiers feature a 2-way crossover and sub-sonic (low-cut) filter for

each channel. Crossover frequencies are fixed at 150 Hz, allowing subwoofers to

be driven at extremely high sound pressure levels, and the filters cut at 40 Hz to

prevent low-end rumble. Using proven technology gained through years of ampli-

fier design, this unit takes advantage of rugged TO-3P output devices mounted

on massive aluminum extrusions and dissipates heat via an extremely quiet and

effective 2-speed fan. CPX amplifiers employ mammoth toroidal power trans-

formers and offer impressive specifications and features not found on similarly

priced competitive units.

These amps are designed to drive a 2-ohm load per channel, thus achieving awe-

some performance levels into 4 ohms in BRIDGE mode. CPX amplifiers are

ruggedly constructed, rack-mountable pieces of gear with superb patching capa-

bility, allowing superior flexibility in application.

Front panel features include calibrated, detented gain (dB) controls and LED indi-

cators for power (PWR), signal presence (SIG), and GCL (Gain Comparator

Limiter) activation on each channel, as well as a rocker mains POWER switch.

The back panel contains an IEC connector for the mains power cord, a mains cir-

cuit breaker with reset, and the critical cooling fan opening. This opening should

have an adequate supply of cool air and should never be blocked or restricted.

Also on the back panel are the input and output sections, including an input bar-

rier strip for permanent installations. Each channel input section includes a combo

XLR / ¼" phone jack connector, THRU/LOW out and HIGH out ¼" jacks, and acti-

vation switches for the LOW CUT filter and crossover (150 Hz XOVER). Channel

output sections feature dual shock-proof binding posts and 4-conductor Speakon

connectors. An additional 4-conductor Speakon connector allows BRIDGE mode

output.