User`s manual
IN-OUT THERMOMETER
WITH CABLE FREE
SENSOR AND RADIO
CONTROLLED CLOCK
USER'S MANUAL
( TE217/TE217EL)
A FOUR-LINE DISPLAY
Facilitates easy reading of remote and indoors
temperatures and calendar clock
B CHANNEL BUTTON
Display different sensor temperature
C MEMORY [MEM] BUTTON
Recalls the maximum or minimum temperature of
main and remote unit
DMODE BUTTON
Toggles the display modes and confirms entry while
setting the values for display
E ALARM BUTTON
Displays the alarm time or sets the alarm status
F SNOOZE BUTTON or SNOOZE/LIGHT BUTTON
Activate the snooze function
GWALL-MOUNT RECESSED HOLE
For mounting the main unit on a wall
HUP ( ) BUTTON
Advances the value of a setting
I DOWN ( ) BUTTON
Decreases the value of a setting
J BATTERY COMPARTMENTS
Accommodates two UM-3 or “AA” size 1.5V
alkaline batteries
KREMOVABLE TABLE STAND
For standing the main unit on a flat surface
English
NILBRAND TE217/TE217EL & TS02C MANUAL (ENG)
SIZE: W65 X H105 (mm)
BY SHAN WONG 28/11/05
A
B
D
F
E
J
H
C
G
K
I
RADIO CONTROLLED
433MHz WIRELESS
ALARM
ON / OFF
MODE
CHANNEL
MEM
PM
PM
AM
M
M
min
w
s
D
D
PRE-AL
ZONE
AM
MIN
MAX
IN
CH
TREND
TREND
When you put the main unit and the remote unit next toe ach
other, you will notice a minimal difference in temperature.
This is caused by the software used and the insulation of the
outdoors sensor, this sensor is calibrated on the average
outdoors temperature, whereas the main unit is calibrated on
the average indoors temperature. This is no defect in the units
At temperatures below freezing point the operation can be
distorted, this is caused because the batteries cannot deliver
the power needed to operate the unit correctly.
You can avoid this by using branded batteries and change
them just before the winter starts.
INTRODUCTION:
Congratulations with the purchase if the In/Out Thermometer
with wireless sensor and radio controlled clock.
The basic package comes with a main unit (the temperature /
clock station) and a remote unit (the thermo sensor).
The main unit has large displays for time/date, indoors
temperature and outdoors temperature as received from the
remote unit. The main unit can receive data from up to 3
remote units.
The main unit has a memory for maximum and minimum
reached temperatures of different sites.
The remote units have a range up to 30 meters, this
range can be influenced by several factors (concrete
walls, electric wires, other sending devices, etc.)
The sensors are weatherproof and can be used outdoors,
but should not be submerged into water or hung in a
place where rain can reach the unit.
The clock/calendar function is radio controlled. The day
can be displayed in 5 languages and the unit has a 2
minute crescendo weekly and daily alarm.
The clock is synchronised with the atom clock in Frankfurt
Germany, this clock has a range of 1.500 km and your
clock will receive the time signal 12 to 24 times a day
and will correct, if necessary. When you first operate
your clock, it can take up to 60 minutes before the radio
signal is received and the correct time is set.
19
20
1817