Installation Instructions

12
Door Installation For Wood Brickmould Units (cont.)
IMPORTANT: Take diagonal
measurements across outside edges of frame.
6. Continue holding unit in place. Square and
plumb jambs. Check both side-to-side and inside-
to-outside (FIGURE 5). Measure from corner-to-
corner to check for square (FIGURES 6 & 7).
7. Use a pry bar to slide bottom of unit left or right
until diagonal measurements are exactly the same.
8. Secure other top corner and check again for
level, plumb and square.
9. Use shims and a straightedge to straighten the
side and top jamb. When straight, fasten through
the the wood brick mould spacing stainless steel
screws 12" on center around head and sides.
NOTE: If maintaining design pressure ratings are
not a concern, galvanized casing nails,
long enough to penetrate framing material
by at least 1-1/2", may be used instead of
screws.
Improper use of hand and power tools could
result in personal injury and/or product damage.
Follow equipment manufacturers’ instructions for
safe operation. Always wear safety glasses.
FIGURE 5
FIGURE 6
FIGURE 7
4-Wide
All
Wd Bk Mld
Cld Nail Fin
Gen - All