Installation Instructions

18
Screen Adjustment
To adjust screen for smooth operation use a
Phillips screwdriver on the adjustment screw in
each screen roller (FIGURES 4 & 4A). Turn clock-
wise to extend the roller or turn counterclockwise
to retract the roller. There are rollers at each
corner, both top and bottom. For best results all
rollers should be adjusted.
NOTE: To raise screen, top rollers need to be
retracted and bottom rollers extended.
To lower screen top rollers need to be
extended and bottom rollers retracted.
Install Screen Keeper
1. Measure 37-1/4" upward from flat top of screen
track and mark the side frame at this point. Mark
should be centered in the frame channel
(FIGURE 5).
2. Position screen keeper so bottom screw hole is
centered over the mark on the side frame.
3. Fasten bottom screw through keeper and into
mark on frame. Fasten top screw. Do not tighten
screws completely.
4. Close screen and activate screen lock to check
for correct alignment. Adjust keeper up or down, if
necessary, for proper locking, then tighten screws.
FIGURE 5
Screen
Track
37 1/4"
Lock
Keeper
Screen
Keeper
Screw
Improper use of hand and power tools could
result in personal injury and/or product damage.
Follow equipment manufacturers’ instructions for
safe operation. Always wear safety glasses.
Screen Adjustment – All Installations
Installing Screen Keeper – All Installations
FIGURE 4
Screen
Roller Adjustment
Screw
1
4A
4-Wide
All
Wd Bk Mld
Cld Nail Fin
Gen - All