Installation Instructions

19
Remove & Install Active Insert
Adjust Active Insert – All Installations
FIGURE 2
FIGURE 3
FIGURE 4
FIGURE 5
FIGURE 1
IMPORTANT:
To achieve DP50
ratings in clad
units,
replace head inside
stop screws (FIGURE
2) with #8 x 3" long
stainless steel screws
(not provided).
Inserts are heavy. Use
caution when handling to
avoid injury or damage. Use
adequate number of people to handle insert.
Prevent damage to sill
track! Check roller position
(one set on each bottom side of each active
insert) before moving active insert. Insert must
be fully supported by roller mechanism. Extend
or retract rollers to achieve insert support.
IMPORTANT: For best results adjust
both sets of rollers at the same time.
Adjust Active Insert – Turn adjusting screw
(FIGURE 1):
Clockwise – Lower Rollers – Raise Insert
Counterclockwise – Raise Rollers – Lower Insert
Use roller adjustment screw (FIGURE 1) to raise or
lower insert to achieve smooth operation and to
keep insert level and plumb.
NOTE: Vinyl plugs are provided to cover
adjustment screw holes. These plugs
can be stained to match your insert.
Removing Active Insert
1. Slide active insert open enough to completely
clear side jamb channel. Slide panel far enough
open so you can grasp both sides.
2. Use a Phillips head screwdriver to fully retract
insert rollers. Turn screw counterclockwise.
3. Use a Phillips screwdriver to remove head
inside stop (FIGURE 2).
4. While holding both sides of insert tilt the insert
top toward you (FIGURE 3).
5. Lift insert off sill track.
Installing Active Insert
IMPORTANT: Clean sill before
installing active insert.
1. With insert upright and rollers (FIGURE 4) down,
position insert close to its side frame. Lift insert
up onto the sill sill track. Be sure interlock will
properly engage inactive insert.
2. Carefully push top of insert away from you until
it is positioned vertically in the frame channel.
NOTE: Both sets of rollers must seat correctly
on the sill track so the insert operates
smoothly. Groove of rollers must rest
on crown of sill track (FIGURE 5).
3. Slide insert to the fully closed position so the
interlocks engage and the insert is secure.
4. While holding insert in place, use a Phillips head
screwdriver to lower insert rollers. Turn screw
clockwise until rollers support insert. Adjust both
sets of rollers.
5. Install head inside stop. 6. Install vinyl hole plugs.
4-Wide
All
Wd Bk Mld
Cld Nail Fin
Gen - All