Installation Instructions

Install Handles and Lock – All Installations

Inserts are heavy. Use

caution when handling to

avoid injury or damage. Use

adequate number of people to safely handle

insert.

NOTE: At this point the active insert must be:

1. Properly installed in the door frame.

2. Rollers properly adjusted.

Follow previous insert installation and roller

adjustment procedures.

1. From the inside, insert a plastic bushing into the

top and bottom holes in door stile (FIGURE 1).

Seat bushings fully.

NOTE: If you ordered a key lock it will be pre-

assembled to the handle. The handle with

the key housing mounts to the outside of

the structure.

The interior handle has a thumb latch to

operate the locking mechanism.

2. Assemble latch shim, thumb latch and interior

handle as shown (FIGURE 2). Remove and

discard plastic protector from thumb latch. Firmly

seat latch shim in holes on interior handle with

thumb latch in center slot (FIGURE 3).

3. Insert handle parts into door stile. Interior handle

to inside; exterior handle to outside with curve of

handles pointing toward the glass (FIGURE 4).

Improper use of hand and power tools could

result in personal injury and/or product damage.

Follow equipment manufacturers’ instructions for

safe operation. Always wear safety glasses.

FIGURE 1

INTERIOR

HANDLE

SCREW

THUMB

LATCH

SHIM

FIGURE 2

FIGURE 3

FIGURE 4

4-Wide

All

Wd Bk Mld

Cld Nail Fin

Gen - All