Installation Instructions

21
Install Handles and Lock – All Installations (cont.)
4. Secure handle assemblies with handle screws
inserted from the interior.
5. Flip thumb latch UP to lock active insert. Flip
thumb latch DOWN to unlock active insert.
6. Locate panel keeper marker (FIGURE 6).
7. Mount to latch by flipping thumb latch to unlock.
Align notches on panel keeper marker with latching
hooks. While holding marker in position between
latching hooks, flip thumb latch to locked position
(FIGURE 7) to hold marker in place.
8. Firmly move active insert against side jamb so
marker makes small dents in side jamb to locate
screw position for keeper (FIGURE 8).
9. Align keeper with marks on side jamb and screw
in place through slotted holes (FIGURE 9). Install
two screws. Close active insert and operate
thumb latch to check operation of latch and
keeper alignment.
If necessary, loosen screws in keeper and adjust
keeper up or down. Check latch operation with
each keeper adjustment. When latch and keeper
are properly aligned tighten two screws and add
the two additional screws through other slotted
screw holes in keeper.
Additional adjustment can be made by moving the
latch hooks in or out by turning screws on latch
face (FIGURE 10).
LOCK
UNLOCK
FIGURE 5
FIGURE 6
FIGURE 7
SCREW
POSITION
MARKS
FOR KEEPER
FIGURE 8
FIGURE 9
LATCH
HOOK
EXTENSION
ADJUSTMENT
SCREW
LATCH
HOOK
LATCH
HOOK
FIGURE 10
4-Wide
All
Wd Bk Mld
Cld Nail Fin
Gen - All