Installation Instructions

23
Recommended Finishing Instructions (cont.)
ACTIVE INSERT
SEAL BARE WOOD
ON TOP OF INSERT.
SEAL BOTH STILES & RAIL.
SEAL BARE WOOD
ON BOTTOM OF INSERT.
SEAL BOTH STILES & RAIL.
DO NOT GET SEALER IN ROLLERS
OR ON WEATHER STRIP.
REMOVE
ACTIVE INSERT
FROM FRAME
Door Inserts
All active and removable door inserts, whether
sliding or hinged, must be removed from the
door frame after installation so they can be prop-
erly sealed (FIGURE 1). See preceding insert
removal instructions.
Both
clad and wood door units have bare wood
on the top and bottom of the inserts. Paint or
varnish these areas as you would all of the other
exposed exterior wood. Follow procedures out-
lined in “Recommended Finishing Instructions”
on previous page.
Do not get paint, varnish or
sealer in the rollers on the
bottom of sliding inserts. Rollers must be
kept clean so they will rotate freely.
Keep all sealers off weatherstrip
or bottom sweeps.
FIGURE 1
4-Wide
All
Wd Bk Mld
Cld Nail Fin
Gen - All