Installation Instructions

27
For Wood Brickmould Units Only
5. Move head and side jambs together so
mitered corner pieces align. Clamp or securely
hold side and head jamb in alignment.
6. Install one #8 x 2" Phillips flat head 401
stainless steel screw through one of the three head
jamb pilot holes. Drive screw down into side jamb
(FIGURE 4BM).
7. Drill and counter sink pilot hole in head jamb
brickmould for #8 x 2-1/2" flat head drywall screw
(FIGURE 5BM).
8. Install remaining two #8 x 2" Phillips flat head
401 stainless steel screws through head jamb pilot
holes (FIGURE 6BM).
9. Apply drywall screw to secure brickmould
corner joint (FIGURE 7BM).
10. Fill brickmould counter sunk screw holes with
exterior grade filler (FIGURE 8BM).
11. Repeat Steps 5 through 11 for other head and
side jamb brickmould joint.
Assemble 4-Wide Door Frame (cont.)
FIGURE 4BM
FIGURE 5BM
FIGURE 6BM
FIGURE 7BM
FIGURE 8BM
4-Wide
All
Wd Bk Mld
Cld Nail Fin
Gen - All