Installation Instructions

31
4-Wide – Inactive Insert Installation (cont.)
Improper use of hand and power tools could
result in personal injury and/or product damage.
Follow equipment manufacturers’ instructions for
safe operation. Always wear safety glasses.
Weight of door unit(s) and accessories will vary. Use
a reasonable number of people with sufficient
strength to lift, carry and install door unit(s) and
accessories. Always consider site conditions and use
appropriate techniques when installing.
8. While standing facing the exterior side of the
supported frame, hold inactive insert vertically with
interlock toward center of opening and pointing
toward the interior (FIGURE 5). Position insert
close to side jamb while leaving enough room for
hands and fingers between side jamb and side of
inactive insert.
9. Still working from the exterior, tilt head of
inactive insert inward (FIGURE 6). Lift insert and
position its head behind the screen track.
10. While holding head in this position, swing
bottom of inactive insert inward and line up with sill
track (FIGURE 7).
11. Lower inactive insert onto sill track and slide
tightly to side jamb (FIGURES 7, 8 & 9).
TOP VIEW
INTERIOR
SCREEN
TRACK
INACTIVE
INSERT
INTERLOCK
FIGURE 5
TILT
INACTIVE
INSERT
POSITION HEAD
OF INACTIVE
INSERT BEHIND
SCREEN TRACK
HEAD
SILL
INTERIOR
FIGURE 6
FIGURE 7
ALIGN
BOTTOM
WITH
SILL
TRACK
LIFT
INACTIVE
INSERT
STRAIGHT UP
INTO HEAD JAMB
HEAD
SILL
INTERIOR
LOWER
INACTIVE
INSERT
ONTO
SILL
TRACK
HEAD
SILL
INTERIOR
FIGURE 8
FIGURE 9
4-Wide
All
Wd Bk Mld
Cld Nail Fin
Gen - All