Installation Instructions

32
Improper use of hand and power tools could
result in personal injury and/or product damage.
Follow equipment manufacturers’ instructions for
safe operation. Always wear safety glasses.
Weight of door unit(s) and accessories will vary. Use
a reasonable number of people with sufficient
strength to lift, carry and install door unit(s) and
accessories. Always consider site conditions and use
appropriate techniques when installing.
12. Insert a 3/4"W x 5/32"T x L (length is
inactive panel width minus 1-3/4") wood shim
into space between top of inactive insert and
head jamb (FIGURE 10).
NOTE: Wood shim must
be inserted. It pre-
vents head jamb from being distorted
when jamb is screwed to top of inactive
insert.
13. While holding insert firmly in place against
side jamb, use #8 x 2" Phillips flat head 401
stainless steel screws through side jamb into
inactive insert to secure side jamb to inactive
insert (FIGURE 11). Start screws 8" down from
top corner of side jamb and apply a screw every
12" to 16" on center along height of side jamb.
14. In a similar manner, using #8 x 2" Phillips
flat head 401 stainless steel screws, secure
head jamb to inactive insert by screwing
through head jamb down into inactive insert.
Start screws 6" from corner of side jamb and
apply a screw every 12" to 16" on center along
width of inactive insert (FIGURE 12).
INSERT
SHIM
4-Wide – Inactive Insert Installation (cont.)
FIGURE 10
SCREW THROUGH
SIDE JAMB INTO
INACTIVE INSERT
SCREW THROUGH
SIDE JAMB INTO
INACTIVE INSERT
ACTIVE INSERTS
SHOWN FOR REFERENCE
SCREEN SHOWN FOR
REFERENCE
SCREW THROUGH
HEAD INTO
INACTIVE INSERT
ACTIVE INSERT
AND SCREEN
SHOWN FOR
REFERENCE
FIGURE 11
FIGURE 12
4-Wide
All
Wd Bk Mld
Cld Nail Fin
Gen - All