Installation Instructions

35
4-Wide – Inactive Insert Installation (cont.)
6. After screws are firmly seated, fill hole with
generous amount of silicone sealant (FIGURE 6).
7. Apply a 1/16" silicone bead around the 9/16"
diameter hole (FIGURE 5).
8. Completely fill the hole plug with silicone sealant
(FIGURE 7).
9. After silicone sealant is applied to all locations
described above, insert screw plugs into each hole
(FIGURE 8).
Make sure plug’s head is fully seated onto the sill.
There should be silicone squeeze out all the way
around the hole plug.
10. Repeat Steps 2 through 9 for each inactive
insert.
After inactive inserts are secured in the frame the
frame/insert assembly can be installed in the rough
opening.
Use care when transporting
assembled unit to rough
opening. Use adequate number of people, do
not flex frame, do not damage alignment of
components.
Follow Installation Instructions
starting on
Page 6 for clad nailing fin units or Page 11 for
wood brickmould units.
• See Page 17 for screen installation.
• See Page 19 for active insert installation.
4-Wide
All
Wd Bk Mld
Cld Nail Fin
Gen - All
FIGURE 5
1/16" BEAD
OF SILICONE
AROUND HOLE
#10 X 1-1/2" PHILLIPS
PAN HEAD TYPE 17
18-8 SS SMS
(1 PER HOLE)
VINYL
HOLE
PLUG
FIGURE 6
FIGURE 7
FILL HOLE PLUG
COMPLETELY WITH
SILICONE SEALANT
BEFORE INSTALLING
PLUG INTO SILL HOLE.
FIGURE 8