- Crestron C2N-VEQ4 Volume Control Manual

Cresnet 4-Channel Digital Volume Control Crestron C2N-VEQ4
30 • Cresnet 4-Channel Digital Volume Control: C2N-VEQ4 Operations Guide - DOC. 6135A
Firmware Upgrade
A firmware upgrade file has the
extension .upg.
To take advantage of all the available features, it is important that the unit contains
the latest firmware. Please check the Crestron website for the latest version of
firmware. Not every product has a firmware upgrade, but as Crestron improves
functions, adds new features, and extends the capabilities of its products, firmware
upgrades are posted. To upgrade the C2N-VEQ4 firmware, complete the following
steps.
1. Make sure that “Communication Settings” that begins on page 26 has
been performed.
2. As shown after this step, select File Transfer | Load Network Device
from the Viewport menu.
File Transfer | Load Network Device Command
3. As shown after this step, select the Net ID of the C2N-VEQ4 and then
click OK. The “Open” window appears (refer to the subsequent
graphic).
“Select Network ID” Window
NOTE: When transferring any Cresnet file (touchpanel project/firmware), lower the
port speed baud rate to 38400 to match the Cresnet bus speed.