User Manual
Table Of Contents
- Isys i/O® 2.8” Handheld WiFi Touchpanel: TPMC-3X
- Introduction
- Setup
- Identity Code
- Battery Installation
- Power
- Battery Calibration
- Configuring the Touchpanel
- General Use and Safety
- Recommended Cleaning
- Programming Software
- Uploading and Upgrading
- Problem Solving
- Appendix: TBD
- Software License Agreement
- Return and Warranty Policies
Crestron TPMC-3X Isys i/O
®
2.8” Handheld WiFi Touchpanel
TPMC-3X-BTP in Battery Compartment of TPMC-3X
5. Re-attach the battery compartment cover.
Power
To charge its internal battery pack, the TPMC-3X must be placed on the included
TPMC-3X-DS docking station/charger. Connect the included power pack to the
TPMC-3X-DS docking station/charger.
NOTE: Before using the TPMC-3X for the first time, charge its internal battery for
at least two hours by placing on the TPMC-3X-DS docking station/charger. The
green LED on the front of the TPMC-3X will blink while the battery is charging.
It takes the TPMC-3X about two hours to recharge while in use. A fully charged
battery can provide up to five hours of use at the full screen brightness setting.
The TPMC-3X has a removable battery pack. With a properly maintained battery,
the design should retain 80% of its original capacity at 300 full charge and discharge
cycles. You may choose to replace your battery when it no longer holds sufficient
charge to meet your needs.
NOTE: When not using the TPMC-3X, store the unit on its docking station/charger.
NOTE: The TPMC-3X can become unresponsive when battery strength is low.
Operations Guide – DOC. 6789C Isys i/O
®
2.8” Handheld WiFi Touchpanel: TPMC-3X • 13