User Manual
Table Of Contents
- Isys i/O® 2.8” Handheld WiFi Touchpanel: TPMC-3X
- Introduction
- Setup
- Identity Code
- Battery Installation
- Power
- Battery Calibration
- Configuring the Touchpanel
- General Use and Safety
- Recommended Cleaning
- Programming Software
- Uploading and Upgrading
- Problem Solving
- Appendix: TBD
- Software License Agreement
- Return and Warranty Policies
Crestron TPMC-3X Isys i/O
®
2.8” Handheld WiFi Touchpanel
The following diagram presents a more complex configuration. In this scenario, the
WAP is connected to a port on the control system’s C2ENET-2 card. The other port
is connected to the corporate LAN. The card’s internal firewall controls data flow,
thus isolating the two subnets.
NOTE: When using a dual-port Ethernet card, Ports A & B must be different
subnets (e.g., Port A = 128.x.x.x; Port B = 192.x.x.x).
For additional information on setting up and understanding an Ethernet network,
refer to the latest version of the Crestron e-Control Reference Guide (Doc. 6052).
TPMC-3X with Multiple Networks
Operations Guide – DOC. 6789C Isys i/O
®
2.8” Handheld WiFi Touchpanel: TPMC-3X • 5