Crestron CWD07234 Two-Way RF Transceiver Module Operations Guide
Regulatory Compliance Federal Communications Commission (FCC) Compliance Statement CAUTION: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Crestron CWD07234 Two-Way RF Transceiver Module Contents Two-Way RF Transceiver Module: CWD07234 ............................................1 Functions and Features .............................................................................................................. 1 Specifications............................................................................................................................. 2 Physical Description ....................................................................
Crestron CWD07234 Two-Way RF Transceiver Module Two-Way RF Transceiver Module: CWD07234 Functions and Features The CWD07234 (hereafter referred to as “module”) with an external SMD antenna, or an integrated SMD antenna, is a two-way radio frequency (RF) module that utilizes the 2.4 GHz frequency band to communicate with other devices. The module operates according to the IEEE 802.15.4 specification and can be configured to minimize the possibility of interference with other devices.
Two-Way RF Transceiver Module Crestron CWD07234 Specifications The table below is a summary of specifications for the CWD07234. Specifications of the CWD07234 SPECIFICATION DETAILS Power Requirements 1.35 W (5.0 Vdc @ 0.27 A) Operating Frequency 2400 MHz to 2483.5 MHz (802.15.4 compliant) Operating Ranges* Minimum Distance 3 ft Maximum Distance Indoors (without repeater device) 550 ft Available Channels 16 (numbered 11 through 26 per 802.15.4) Internal Antenna Gain: 1.8 dBi max.
Crestron CWD07234 Two-Way RF Transceiver Module Physical Description The module consists of various components on a printed circuit board (PCB). There are two build options: 1. An onboard antenna (refer to CWD07234-1) 2. A detached antenna (refers to CWD07234-2) The detached antenna connects to the PCB through a 3 inch cable to a U.FL connector. Physical View of CWD07234-1 Operations Guide - DOC.
Two-Way RF Transceiver Module Crestron CWD07234 Physical View of CWD07234-2 Ports The module contains an 11-pin double row connector. Refer to the diagram that follows. CWD07234 Power / I-O Pin Configuration 4 Two-Way RF Transceiver Module: CWD07234 Operations Guide - DOC.
Crestron CWD07234 Two-Way RF Transceiver Module Power/I-O The 11-pin header double row connector provides power to the module as well as the communications between the module and wired devices. Refer to the following table for pin assignments of the module interface connector.
Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 Tel: 888.CRESTRON Fax: 201.767.7576 www.crestron.com Operations Guide – DOC. 7520A 03.13 Specifications subject to change without notice.
