Crestron CWD1016 Two-Way RF Transceiver Module Hardware Guide
This document was prepared and written by the Technical Documentation department at: Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 1-888-CRESTRON All brand names, product names and trademarks are the property of their respective owners. ©2008 Crestron Electronics, Inc.
Crestron CWD1016 Two-Way RF Transceiver Module Contents Two-Way RF Transceiver Module: CWD1016 .......................................2 Introduction ............................................................................................................................... 2 Functions and Features ................................................................................................ 2 Specifications ............................................................................................
Two-Way RF Transceiver Module: CWD1016 Introduction Functions and Features The CWD1016 (hereafter referred to as “module”) is a two-way radio frequency (RF) module that utilizes the 2.4 GHz frequency band to communicate with other devices. The module operates according to the IEEE 802.15.4 specification and can be configured to minimize the possibility of interference with other devices.
Crestron CWD1016 Two-Way RF Transceiver Module Specifications The table below is a summary of specifications for the CWD1016. Specifications of the CWD1016 SPECIFICATION DETAILS Power Requirements Sleep Receive Transmit Operating Frequency Typical <5uA Typical 28mA Typical 150mA Max 11uA Max 35mA Max 165mA 2400 MHz to 2483.5 MHz (802.15.
CWD1016 Detail Views . Power/I-O An edge connector provides power to the module as well as serial communications between the module and wired devices. Refer to the following table for pin assignments of the module interface connector.
Crestron CWD1016 Two-Way RF Transceiver Module Antenna The board mounted chip antenna port is located at edge of the circuit board. Industry Compliance Labeling Requirements If the FCC ID on the CWD1016 is not visible when the module is installed inside another device, then the outside of the device into which the module is installed must also display a label referring to the enclosed module.
“Contains Transmitter Module FCC ID: EROCWD1016” or “Contains FCC ID: EROCWD1016” The OEM of the CWD1016 Module must only use the approved antenna, which has been certified with this module. The OEM of the CWD1016 Module must test their final product configuration to comply with Unintentional Radiator Limits before declaring FCC compliance per Part 15 of the FCC rules.
Crestron CWD1016 Two-Way RF Transceiver Module “IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, only the antenna provide with this transmitter may be installed and this device must not be colocated or operating in conjunction with any other antenna or transmitter.” Compliance Statement (Part 15.19) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2.
This page intentionally left blank Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 Tel: 888.CRESTRON Fax: 201.767.7576 www.crestron.com Hardware Guide - DOC. 6351 02.28 INTERNAL USE ONLY Specifications subject to change without notice.
Crestron CWD1016 Hardware Guide - DOC.
