User Manual

Crestron CWD1016 Two-Way RF Transceiver Module
Hardware Guide - DOC. Contents • 5
Antenna
The board mounted chip antenna port is located at edge of the circuit board.
Industry Compliance
Labeling Requirements
If the FCC ID on the CWD1016 is not visible when the module is installed inside
another device, then the outside of the device into which the module is installed must
also display a label referring to the enclosed module. This exterior label can use
wording such as the following: “Contains Transmitter Module FCC ID:
EROCWD1016” or “Contains FCC ID: EROCWD1016.” Any similar wording that
expresses the same meaning may be used.
Compliance Statement (Part 15.19 )
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference
that may cause undesired operation.
Warning (Part 15.21 )
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
RF Exposure (OET Bulletin 65 )
To comply with FCC RF exposure requirements for mobile transmitting devices, this
transmitter should only be used or installed at locations where there is at least 20 cm
separation distance between the antenna and all persons. This device must not be co-
located or operating in conjunction with any other antenna or transmitter within the
host device it is installed into.
Industry Canada Statement
Section 7.1.5 of RSS-GEN
Operation is subject to the following two conditions:
1) this device may not cause interference, and
2) this device must accept any interference, including interference that may cause
undesired operation of the device.
OEM Integration :
OEM Responsibility to the FCC Rules and Regulations
The CWD1016 Module has been certified per FCC Part 15 rules for integration into
products without further testing or certification.
To fulfill the FCC certification requirements the OEM of the CWD1016 Module
must ensure that the information provided on the CWD1016 label is placed on the
outside of the final product.
The CWD1016 Module is labeled with its own FCC ID Number. If the FCC ID is
not visible when the module is installed inside another device, then the outside of the
device into which the module is installed must also display a label referring to the
enclosed module.
This exterior label can use wording such as the following: