User Manual

Crestron Electronics, Inc. Hardware Guide - DOC. 6351
15 Volvo Drive Rockleigh, NJ 07647 02.28
Tel: 888.CRESTRON INTERNAL USE ONLY
Fax: [phone] Specifications subject to
www.crestron.com change without notice.
“Contains Transmitter Module FCC ID: EROCWD1016”
or
“Contains FCC ID: EROCWD1016”
The OEM of the CWD1016 Module must only use the approved antenna, which has
been certified with this module.
The OEM of the CWD1016 Module must test their final product configuration to
comply with Unintentional Radiator Limits before declaring FCC compliance per
Part 15 of the FCC rules.
IMPORTANT NOTE: In the event that these conditions cannot be met (for
example co-location with another transmitter), then the FCC authorization is no
longer considered valid and the FCC ID cannot be used on the final product. In these
circumstances, the OEM integrator will be responsible for reevaluating the end
product (including the transmitter) and obtaining a separate FCC authorization.
Setup
Hardware Hookup
Refer to the /I-O Pinout Signals table which shows the connections made to the
module.
NOTE: To prevent unit-to-unit RF interference, multiple modules operating at the
same frequencies should not be installed within three to five feet of each other.
Antenna
The module is provided with an internal antenna.
Mounting
The module has an edge connector for surface mounting to a printed circuit board
(PCB).
End Product Labeling
The final end product must be labeled in a visible area with the following: “Contains
FCC ID: EROCWD1016 .
Documentation
The OEM integrator has to be aware not to provide information to the end user
regarding how to install or remove this RF module in the users manual of the end
product which integrate this module.
The users manual for OEM integrators must include the following information in a
prominent location