Crestron CWD7041 Two-Way RF Transceiver Module with Integral Antenna Operations Guide
This document was prepared and written by the Technical Documentation department at: Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 1-888-CRESTRON Regulatory Compliance Federal Communications Commission (FCC) Compliance Statement This device complies with part 15 of the FCC Rules.
Crestron CWD7041 Two-Way RF Transceiver Module with Integral Antenna Contents Two-Way RF Transceiver Module with Integral Antenna: CWD7041 .........1 Functions and Features .............................................................................................................. 1 Specifications............................................................................................................................. 2 Physical Description .............................................................
Crestron CWD7041 Two-Way RF Transceiver Module with Integral Antenna Two-Way RF Transceiver Module with Integral Antenna: CWD7041 Functions and Features The CWD7041 (hereafter referred to as “module”) is a two-way radio frequency (RF) module that utilizes the 2.4 GHz frequency band to communicate with other devices. The module operates according to the IEEE 802.15.4 specification and can be configured to minimize the possibility of interference with other devices.
Two-Way RF Transceiver Module with Integral Antenna Crestron CWD7041 Specifications The table below is a summary of specifications for the CWD7041. Specifications of the CWD7041 SPECIFICATION DETAILS Power Requirements 0.22 Watts (3.3VDC @ 0.067A) Operating Frequency 2400 MHz to 2483.5 MHz (802.15.4 compliant) Operating Ranges* Minimum Distance 3 ft Maximum Distance Outdoors (without repeater device) 550 ft Available Channels 16 (numbered 11 through 26 per 802.15.
Crestron CWD7041 Two-Way RF Transceiver Module with Integral Antenna CWD7041 Detail View 1.57 in (4.00 cm) 1.25 in (3.18 cm) Ports The module contains a 25-pin header. Refer to the diagrams and descriptions that follow. Power/I-O The 25-pin header provides power to the module, serial communications between the module and wired devices, as well as connections to the debug port. Refer to the following table for pin assignments of the module interface connector.
Two-Way RF Transceiver Module with Integral Antenna Crestron CWD7041 Labeling Requirements If the FCC identification number is not visible when the module is installed inside another device, then the outside of the device into which the module is installed must also display a label referring to the enclosed module. This exterior label can use wording such as the following: “Contains Transmitter Module FCC ID: EROCWD7041” or “Contains FCC ID: EROCWD7041.
Crestron CWD7041 Two-Way RF Transceiver Module with Integral Antenna This page is intentionally left blank. Operations Guide - DOC.
Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 Tel: 888.CRESTRON Fax: 201.767.7576 www.crestron.com Operations Guide – DOC. 7263A 06.11 Specifications subject to change without notice.
