User's Manual

This document was prepared and written by the Technical Documentation department at:

Crestron Electronics, Inc.

15 Volvo Drive

Rockleigh, NJ 07647

1-888-CRESTRON

Regulatory Compliance

Federal Communications Commission (FCC) Compliance Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following conditions:

(1) This device may not cause harmful interference and (2) this device must accept any interference received,

including interference that may cause undesired operation.

CAUTION: Changes or modifications not expressly approved by the manufacturer responsible for compliance

could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B device, pursuant to part

15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio frequency energy and if not installed

and used in accordance with the instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or more if the following measures:

• Reorient or relocate the receiving antenna

• In

crease the separation between the equipment and receiver

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected

• Consult the dealer or an experienced radio/TV technician for help

Industry Canada (IC) Compliance Statement

Operation is subject to the following two conditions:

1. This device may not cause interference, and

2. This device must accept any interference, including interference that may cause undesired operation of the

device.

To satisfy RF exposure requirements, this device and its antenna must operate with a separation distance of at least

20 centimeters from all persons and must not be collocated or operating in conjunction with any other antenna or

transmitter.

All brand names, product names and trademarks are the property of their respective owners.

Le fonctionnement est soumis

aux deux conditions suivantes:

1. Cet appareil ne doit pas provoquer d'interférences et

2. Cet appareil doit accepter toute interférence, y compris les interférences pouvant entraîner un fonctionnement non

dispositif.

Pour satisfaire aux exigences d'exposition RF, ce dispositif et son antenne doivent fonctionner avec une distance de

séparation d'au moins À 20 centimètres de toutes les personnes et ne doit pas être collocée ou fonctionner en conjonction

avec une autre antenne ou émetteur.