Crestron ZUMMESH NETBRIDGE Wireless Room System Network Bridge Installation & Operations Guide
Regulatory Compliance [UL Compliance Underway] Federal Communications Commission (FCC) Compliance Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
Description The Crestron® ZUMMESH NETBRIDGE is designed for the Wireless Room System to be monitored and controlled from a centralized Crestron Control System. The Network Bridge plugs into any J-Box Wireless Room System device and wirelessly communicates to a Crestron CEN-GWEXER Gateway. The Network Bridge provides basic information to the Crestron Gateway regarding room status, devices within the room etc.The Network Bridge also includes a BlueTooth LE connection allowing system setup via a smart phone.
Specifications Specification Detail Power Requirements 5V, 280mA Environmental Temperature Humidity 32° to 104°F (0° to 40°C) 10% to 90% RH (non-condensing) Enclosure UL 5VA plastic Mounting Attaches to any ZUMMESH J-Box Load Controller model: GL-WRS-DIMFLV* GL-WRS-HSW* GL-WRS-PWS*
Installation WARNING: To avoid fire, shock, or death, turn off power at circuit breaker or fuse before installing! NOTES: Observe the following points. • Codes: Install in accordance with all local and national electrical codes. • Temperature: For use where temperatures are between 32° to 104°F (0° to 40°C). Install the ZUMMESH NETBRIDGE 1. Turn the power off at the circuit breaker. 2. Remove cover from J-Box device 3. Plug in ZUMMESH NETBRIDGE 4. Restore power at the circuit breaker.
Wireless Communication The device connects to the wireless room system via physical connection to the J-Box device. The Network Bridge connects to the Crestron ZUMMESH Gateway using Crestron ZUMMESH protocol. Use the procedures outlined below to join or leave the Crestron ZUMMESH Network. Joining a Crestron EX Network 1. Place Gateway into Acquire mode – see Gateway Instruction manual. 2.
Return and Warranty Policies Merchandise Returns / Repair Service 1. No merchandise may be returned for credit, exchange or service without prior authorization from CRESTRON. To obtain warranty service for CRESTRON products, contact an authorized CRESTRON dealer. Only authorized CRESTRON dealers may contact the factory and request an RMA (Return Merchandise Authorization) number. Enclose a note specifying the nature of the problem, name and phone number of contact person, RMA number and return address. 2.
