Crestron 1700C-BEZEL Bezel Kit Operations & Installation Guide .
This document was prepared and written by the Technical Documentation department at: Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 1-888-CRESTRON All brand names, product names and trademarks are the property of their respective owners. ©2003 Crestron Electronics, Inc.
Crestron 1700C-BEZEL Bezel Kit Contents Bezel Kit: 1700C-BEZEL 1 Introduction......................................................................................1 Installation........................................................................................2 Problem Solving...............................................................................4 Troubleshooting.....................................................................4 Further Inquiries .........................................
Crestron 1700C-BEZEL Bezel Kit Bezel Kit: 1700C-BEZEL Introduction The Bezel Kit (1700C-BEZEL) includes the material to eliminate “quick” pushbuttons from a Crestron 1700 Series touchpanel. A replacement bezel without button openings is included in the kit. NOTE: Recall that each pushbutton had a command with fixed digital join number in the SIMPL Windows program.
Bezel Kit Crestron 1700C-BEZEL Installation Perform the following to remove the existing bezel, pushbuttons, and supporting parts from the Series 1700 touchpanel and install the new replacement bezel. A #1 Phillips screwdriver is required. Refer to the illustrations that accompany the procedure. 1. Remove the battery and place the touchpanel face down on a clean padded work surface. 2. Remove the four screws that secure the front bezel to the base and return the unit to its normal position.
Crestron 1700C-BEZEL Bezel Kit NOTE: The pushbuttons usually fit snugly on the membrane switch actuators. Therefore the two items may be removed as one piece. NOTE: Some touchpanels may have adhesive holding the membrane switch actuators to the PCB. For these units, peel back the actuators. If there is any residual adhesive on the PCB, wipe it away with a clean soft cloth slightly dampened with isopropyl alcohol.
Bezel Kit Crestron 1700C-BEZEL Assembled View of Touchpanel with Bezel Kit 6. Hold the bezel to the touchpanel base and carefully rotate the entire panel onto its face once more. 7. Reinstall the four screws to secure the bezel to the base. Tighten the screws, being careful not to strip the threads. 8. Reinstall the battery and verify that the touchpanel functions properly.
Crestron 1700C-BEZEL Bezel Kit Further Inquiries If, after reviewing this Operations and Installation Guide for the bezel kit, you cannot locate specific information or have questions, please take advantage of Crestron's award winning customer service team in your area. Dial one of the following numbers. • In the US and Canada, call Crestron's corporate headquarters at 1-888-CRESTRON [1-888-273-7876]. • In Europe, call Crestron International at +32-15-50-99-50.
Bezel Kit Crestron 1700C-BEZEL Return and Warranty Policies Merchandise Returns / Repair Service 1. No merchandise may be returned for credit, exchange, or service without prior authorization from CRESTRON. To obtain warranty service for CRESTRON products, contact the factory and request an RMA (Return Merchandise Authorization) number. Enclose a note specifying the nature of the problem, name and phone number of contact person, RMA number, and return address. 2.
Crestron 1700C-BEZEL Bezel Kit This page intentionally left blank. Operations & Installation Guide - DOC.
Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 Tel: 888.CRESTRON Fax: 201.767.7576 www.crestron.com Operations & Installation Guide - DOC. 6252 11.03 Specifications subject to change without notice.
