User Guide

Wall Mount Back Box for STX-1700CW Crestron BB-1700CW
Back Box Enclosure Physical Views and Dimensions
6.63 in
(16.85 cm)
3.75 in
(9.53 cm)
5.99 in
(15.21 cm)
Installation
There are two different methods of installing the BB-1700CW; installation during
construction or post-construction installation. Installation during construction
describes installation into a room during construction when the room is framed and
the gypsum board has not been hung. The post-construction method is used after the
rooms are complete and gypsum board has already been hung.
Installation During Construction
This section describes installation into a room during construction when the room is
framed and the gypsum board has not been hung. Before the gypsum board is hung,
complete the following procedure in the order provided. The only tool required is a
#2 Phillips screwdriver.
NOTE: This procedure installs the left-side of the back box to the right-side of a
framing stud. If installing the back box to the left-side of a stud, reverse the
mounting bracket and the mounting support bracket but maintain the orientation of
the back box enclosure with the manual unlatching notch at the top.
1. Locate the position and height that the back box (and touchpanel) will
be installed.
2 • Wall Mount Back Box for STX-1700CW: BB-1700CW Installation Guide – DOC. 6105