User Guide

Crestron BB-1700CW Wall Mount Back Box for STX-1700CW
2. Refer to the diagram below. Position the mounting bracket at the edge
of the stud. Through the upper and bottom-most mounting bracket
slots and using a #2 Phillips screwdriver, secure the bracket to the stud
using four screws (not supplied).
Secure Mounting Bracket to Stud
3. Orient the back box enclosure as shown below (notch for manual
unlatching upwards) and remove an appropriate knockout for the
Cresnet wiring.
Back Box Enclosure Orientation
NOTCH
FOR MANUAL
UNLATCH TAB
ACCESS
REMOVED
KNOCKOUT
Installation Guide – DOC. 6105 Wall Mount Back Box for STX-1700CW: BB-1700CW • 3