User Guide

Crestron C2N-IIF Intercom Interface
Specifications of the C2N-IIF (continued)
SPECIFICATION
DETAILS
Outputs (continued)
Audio Power Amplifier (1) Located at “AV IO” connector
(“SPK+” and “SPK-“ terminals)
Number of Channels
Load
Output Power
THD + Noise
Signal-to-Noise Ratio
Frequency Response
Input Source Selection
Mute
Recommended
Speaker
Single (mono)
8 Ohm speaker
13 Watts (Max average power)
< 0.5% at 13 Watts, 100 Hz to 20 KHz
80 dB (1 KHz, rated output power)
+ / - 1 dB, 100 Hz to 20 KHz
Electronic
Electronic
Any 8 Ohm speaker
Microphone Audio (1) Located at “AUDIO” connector
Output Level
Frequency Response
Volume Control
1 VRMS
+ / - 5 dB, 1 KHz to 20 KHz
MIC VOL potentiometer
Essex Panel Power
Signal Level
Short Circuit Protection
(1) Located at “INPUT” connector
5 VDC
Re-settable fuse, 0.3 A nominal
Essex Lamp Control
On / Off Control
(1) Located at “INPUT” connector
Electronic
C2N-IIF Firmware C2N-IIF.v1.1.upg or later
Control System Update
Files
1,2,3
2-Series Control System
MP2/MP2E
CNMSX-AV/PRO
CNRACKX/-DP
Version C2-V2004.CUZ or later
Version MP2-V3062.CUZ or later
Version 5.12.63X.UPZ or later
Version 5.12.63W.UPZ or later
(continued on next page)
Operations & Installation Guide - DOC. 6235 Intercom Interface: C2N-IIF • 7