User Guide

Intercom Interface Crestron C2N-IIF
Uploading a VT Pro-e Project
The C2N-IIF
Intercom
Interface
source file has
the extension
.vtp. A
compiled VT
Pro-e file has
the extension
.hex.
The VT Pro-e file can be uploaded to the C2N-IIF using VT Pro-e or via
the Crestron Viewport.
Upload via VT Pro-e
1. Start VT Pro-e.
2. Select File | Open | Project to view the “Open” window,
navigate to the VT Pro-e file (.vtp), and click Open.
3. Select File | Upload Project. This automatically selects the
compiled .hex file.
Upload via Crestron Viewport
1. Verify that the procedure for “Communication Settings” that
begins on page 37 has been performed.
2. As shown after this step, select File Transfer | Send
Network Device Sound/Data File… from the Viewport
menu.
File Transfer | Send Touchpanel Network Device Sound/Data
File…Command
NOTE: If using a version of Viewport prior to version 3.81, use the
Send Touchpanel command.
3. As shown after this step, select the Net ID of the C2N-IIF
and then click OK. The “Open” window appears (refer to the
following graphics).
42 • Intercom Interface: C2N-IIF Operations & Installation Guide - DOC. 6235