Specifications

Crestron C2N-MMS Professional Multimedia Switch
RGBHV Pinouts
PIN FUNCTION PIN FUNCTION
1 Red Video 9 No Connect
2 Green Video 10 Ground
3 Blue Video 11 No Connect
4 Reserved 12 Monitor Sense (input) /
No Connect (output)
5 Ground 13 Horizontal Sync
6 Red Ground 14 Vertical Sync
7 Green
Ground
15 Monitor Sense Clock (input) /
No Connect (output)
8 Blue Ground
NET
Two 4-position terminal block connectors are used to connect the C2N-MMS to the
Cresnet system. Data and power for the C2N-MMS are provided via either
connection. Refer to “Network Wiring” on page 8.
NET Pinouts
PIN # DESIGNATION DESCRIPTION
1 24 Power
2 Y Data
3 Z Data
4 G Ground
SETUP LED and Pushbutton
The C2N-MMS is Touch Settable (TSID) ready. The SETUP pushbutton and its
associated LED are located on the rear panel and are used for setting up the unit’s
network ID during the initial configuration of a Cresnet system or when the device is
being added/replaced. Refer to “Identity Code” on page 9 for detailed information.
Industry Compliance
As of the date of manufacture, the C2N-MMS has been tested and found to comply
with specifications for CE marking and standards per EMC and
Radiocommunications Compliance Labelling.
NOTE: This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
Operations Guide – DOC. 6374 Professional Multimedia Switch: C2N-MMS • 7