User Guide

Crestron C2N-MNETGW infiNET™ Gateway/Transceiver
For systems with one gateway and minimal interference from other
devices that use similar frequencies, Crestron recommends setting the
C2N-MNETGW to automatically select the operating channel.
For systems using multiple gateways or systems operating in
environments containing other devices that use similar frequencies,
Crestron recommends setting the C2N-MNETGW to operate on a fixed
channel to avoid RF interference with other devices in the vicinity.
Ideally, each gateway should operate on its own channel to avoid
interfering with other gateways operating in the vicinity. The infiNET
signal protocol prevents data intended for one gateway and its devices
from being received by another gateway and its devices. For detailed
information on infiNET channels, refer to “Appendix A: The infiNET
Spectrum” on page 38.
Channel settings are made through Crestron Toolbox as shown in the
following procedure.
1. Ensure that all network devices are connected to the control
system.
2. Open Crestron Toolbox and establish communications with the
control system (refer to “Establishing Communications” on page
27).
3. Select the Network Device Tree
icon, or select Tools |
Network Device Tree.
“Network Device Tree” Window
Operations Guide - DOC. 6317 infiNET™ Gateway/Transceiver: C2N-MNETGW • 13