User Guide

Crestron C2N-MNETGW infiNET™ Gateway/Transceiver
Acquiring Devices
An infiNET device can communicate with a gateway only if it has been
acquired by that gateway (even if the gateway and the device are
operating on the same channel). To add infiNET devices to the network,
the C2N-MNETGW must be in the Acquire mode. The Acquire mode can
be activated from Crestron Toolbox (recommended) or the device. The
Acquire mode can be activated approximately 15 seconds after applying
power to the C2N-MNETGW.
NOTE: In an environment with multiple gateways, only one gateway
should be in the Acquire mode at a time.
Entering the Acquire mode from Crestron Toolbox provides the installer
with a visual account of devices as they are acquired. To enter the
Acquire mode from Crestron Toolbox, do the following:
1. Open the “MNET Gateway” window as described in steps 1
through 4 on page 13.
“MNET Gateway” Window
Operations Guide - DOC. 6317 infiNET™ Gateway/Transceiver: C2N-MNETGW • 15