User Guide

InfiNET™ Gateway/Transceiver Crestron C2N-MNETGW
NOTE: If the C2N-MNETGW is already in the Acquire mode, a
message indicating the status will be displayed.
Acquire Mode Message
2. To place the C2N-MNETGW in the Acquire mode, click Start
Acquire.
The default time that the C2N-MNETGW remains in the Acquire
mode (when starting the Acquire mode from Toolbox) is one hour.
Other times can be specified from the drop down button located
next to the Start Acquire button. The Acquire LED on the
C2N-MNETGW will illuminate and the Start Acquire button will
change to read STOP Acquire.
NOTE: The C2N-MNETGW must be placed in the Acquire mode
before an infiNET device is placed in the Acquire mode.
NOTE: While the “MNET Gateway” window is open and the
device is in the Acquire mode, the control system is in passto
mode. The program in the control system is paused and will
resume after leaving the Acquire mode.
3. Place new infiNET devices in the Acquire mode as described in
their respective manuals. Devices will be automatically acquired
by the gateway approximately five minutes after they enter the
Acquire mode.
4. At any time, click STOP Acquire to exit the Acquire mode. The
Acquire LED will turn off. Newly acquired devices will be shown
in addition to any existing devices as shown in the following
diagram.
16 • infiNET™ Gateway/Transceiver: C2N-MNETGW Operations Guide - DOC. 6317