Installation guide

Network Video Streamer Crestron CEN-NVS200
56
•
Network Video Streamer: CEN-NVS200 Operations & Installation Guide – DOC. 7111E
Configuring Camera Control Settings
To configure camera control settings, click Configuration on the CEN-NVS200
home page, then click Camera Control in the column on the left side of the page.
The “Camera Control” configuration page opens.
“Camera Control” Configuration Page
NOTE: The “Camera Control” configuration page can also be accessed by entering
the following URL in the web browser:
http://Video Streamer/setup/camera_control.html
Video Streamer is the host name or IP address of the CEN-NVS200.
1. Select one of the following radio buttons:
• Disable: Select Disable if the camera is a fixed camera or does not
support PTZ features. If Disable is selected, camera control functions
on the “Camera Control” page are not displayed.
• PTZ Camera: Select PTZ Camera to configure the camera ID, camera
driver, and RS-485 port settings.
• Transparent HTTP Tunnel: Select Transparent HTTP Tunnel for a
PTZ camera to allow the CEN-NVS200 to forward UART commands.
The UART commands are sent through the HTTP tunnel established
between the user and the CEN-NVS200 and are transmitted to the
device connected to the CEN-NVS200.
When Transparent HTTP Tunnel is selected, only RS-485 port settings
can be configured.
2. (Applicable only when PTZ Camera is selected) In the Camera ID text
entry box, enter the ID specific to the camera. The camera ID is necessary
for multiple camera control. Refer to the PTZ camera documentation for ID
settings.