User Guide
Ethernet Enabled Programmable TV/AV Controller Crestron CEN-TVAV
Ethernet Setup
This section explains how to configure a CEN-TVAV to communicate over Ethernet
using the TCP/IP. These procedures assume that the CEN-TVAV has been powered
up. Connection to a LAN/WAN via a hub is not required for these procedures.
Initial IP Setup
NOTE: This initial IP setup MUST be done via the RS-232 port. Before performing
the procedures in this section, refer to the “Cable Configuration for Programming”
on page 8 for cabling instructions. Thereafter, communications may be achieved by
using the Crestron Viewport to directly connect to the IP address assigned to the
CEN-TVAV. It is assumed that the user has communications with the CEN-TVAV
and the appropriate update file has been loaded.
1. From the Crestron Viewport, select Functions | Set Control System
IP Information, as shown below.
Set IP Information via Viewport
24
• Ethernet Enabled Programmable TV/AV Controller: CEN-TVAV Operations Guide - DOC. 5720A