User Guide

Crestron CEN-TVAV Ethernet Enabled Programmable TV/AV Controller
2. Turn the CEN-TVAV over to bottom-side up.
3. Refer to the diagram below. Using a #1 Phillips screwdriver, remove
the four cover screws.
Remove Cover Screws
4. Slide the cover rearward and remove.
5. Turn the CEN-TVAV over to top-side up.
6. From the front panel, the fuse assembly is located at the left-rear corner
of the CEN-TVAV. As shown below, remove fuse by pulling top of
fuse straight up.
Remove Fuse
NOTE: If a resistance checker is available, verify that fuse is open/maximum
resistance. If fuse is good/no resistance, contact Crestron customer service. If fuse is
verified open, continue to the next step.
7. Replace fuse with same type and rating. As shown on the next page,
align the fuse and fuse base pins and install.
Operations Guide - DOC. 5720A Ethernet Enabled Programmable TV/AV Controller: CEN-TVAV
37