Installation guide

802.11a/b/g Wireless Access Points Crestron CEN-WAP-ABG
“IEEE 802.1x/RADIUS” Page
Refer to the configuration guidelines that follow.
Primary RADIUS server address: Enter the IP address of the primary RADIUS
server.
NOTE: The access point can be configured to communicate with two RADIUS
servers: a primary server and a secondary server. If the primary RADIUS server fails
to respond, the access point can try to communicate with the secondary RADIUS
server.
Secondary RADIUS server address: Enter the IP address of the secondary RADIUS
server.
Timeout (sec): Enter the maximum number of seconds that must pass before the
access point can try to communicate with the secondary RADIUS server after failing
to communicate with the primary RADIUS server. The default setting is 5.
Max number of retries: Enter the maximum number of times the access point can try
to communicate with the primary RADIUS server after the initial attempt fails.
When the maximum number of retries is reached and communication with the
primary RADIUS server fails, the access point can try to communicate with the
secondary RADIUS server. The default setting is 3.
RADIUS authentication port: Enter the authentication port number of the RADIUS
server. The default setting is 1812.
NOTE: The RADIUS authentication port is officially assigned to UDP port 1812.
RADIUS servers of Microsoft Corporation default to port 1812; however, RADIUS
servers of Juniper Networks, Inc. and Cisco Systems, Inc. default to port 1645.
36 • 802.11a/b/g Wireless Access Points: CEN-WAP-ABG Operations & Installation Guide – DOC. 6695C