Specifications

Crestron CLS/CLSI-C6 & CLS/CLSI-C6M iLux Integrated Lighting System
Operations Guide – DOC. 6347G iLux Integrated Lighting System: CLS/CLSI-C6 & CLS/CLSI-C6M • 33
⇒ Any time all six lighting loads are off, all seven of these LEDs glow at
a low intensity (to allow finding the CLS-C6 unit in the dark).
Toggle-Scene Buttons
• Used to alternately recall a scene or turn scene lights off (i.e., have the
specified lighting loads go to off, in the specified time).
• The toggle scene function should not be assigned to any scene that includes
shades.
• Note that the ON and OFF buttons are fixed recall-scene buttons and
cannot be defined to toggle. (However, a remote keypad button can be
defined to toggle the On scene, but not the Off scene.)
• The LED is on only if any lighting load in the scene is above 0% (ignores
state of shades).
• Pressing the button while all lights are off (LED off) recalls a scene.
Pressing it while any lights are on (LED on) turns that scene’s lights off.
• During scene recall, the scene LED flashes until all affected lighting loads
reach their target levels. After this the LED remains on steady until all
affected lights go off.
• During scene turn off, the LED flashes until all affected lighting loads reach
0%. After this, the LED is off until any affected light turns on.
• Pressing a scene button while its LED is flashing performs a scene cut
(during either recall or turn off).
• Behavior of the 2-digit display is the same as for scene recall.
Master (Last Scene) Raise/Lower Buttons
• Press the right side to raise lights, the left side to lower, and release to stop.
• All dimmable lighting loads ramp up or down at a fixed rate, which is the
same rate as used for individual up/down operation in Lights mode.
• Non-dim lighting loads are not affected.
• The feedback LED lights while the button is being pressed.
Lighting Master (Last Scene) Raise Buttons
• Same as master raise/lower button, except that pressing any part of the
button raises the lights.
Lighting Master (Last Scene) Lower Buttons
• Same as master raise button, except that pressing the button lowers lights
instead of raising them.
Shade Control (Open/Stop/Close/Stop) Buttons
• Used to control the specified shade group or all shade groups.
• Press the right side of the function buttons to open the shades; press the left
side to close them. Press the button while the shade is moving to stop it.
• The feedback LED is on only while a button is pressed.